Build a car for you, not for them ! (the oil companies!)
|
CHARGING ACCESSORIES
CHARGING PORT "AUTO-EJECTS" These auto ejects will automatically eject
your charging cord when your "ignition" is turned on. Never drive off with your
charging cord still attached !The super ejects disconnect power before cord
ejection.
Units can be used with or without included covers- we mount them in the old
gas fill tube hole (without the covers shown)
NOTE: Ejection solenoid cannot be energized continuously-use time delay
relay,ignition key "start"position
or the "super special" eject below!
STANDARD 20A AUTO EJECT
SEALED 20A SUPER EJECT
SEALED 30A SUPER EJECT
The Auto Eject Standard is a
power input connector designed to be
mounted in the vehicle to permit
connecting a 120 Volt A.C. or 250 Volt A.C.
shore line. It comes with a weatherproof
cover. The cover is spring loaded to close,
preventing water from entering when the
shore line is not connected. A solenoid
wired to the vehicle’s starter is energized
when the engine is cranked. This
instantaneously drives the plug from the
receptacle. This simple reliable device
eliminates forever the broken cables which
result when drivers forget to remove the
shore line before driving away.
The Super Auto Eject is a
completely sealed automatic power line
disconnect. This prevents contamination of
the mechanism by road dirt and ensures
long reliable life even when mounted in
the most severe environment. A novel
internal switch arrangement closes and
opens the 120 volt A.C. circuit after the
mating connector is inserted and before the
connector is removed. This eliminates
arcing at the connector contacts and
assures long contact life. As with
all Auto Ejects, the Super Auto Eject is
connected to the starter circuit so that
ejection occurs when the engine is cranked.
The Super 30 Auto Eject is a
completely sealed automatic power line
disconnect. This prevents contamination of
the mechanism by road dirt and ensure
long reliable life even when mounted in the
most severe environment. A novel plug
detector closes and opens the 120 volt A.C.
circuit after the mating connector is
inserted and before the connector is
ejected. This eliminates arcing at the
connector contacts and assures long
contact life. As with all Auto Ejects, the
Super 30 Auto Eject is connected to the
starter circuit so that ejection occurs when
the engine is cranked.
Super 30 Auto Eject supplied complete
with 230V Mating Connector, Mounting
Plate and 12 Volt Solenoid.
Four pin also available
Specify 120 or 240 volt










The Super Special Auto Eject is a
special version of the standard Super Auto
Eject automatic shoreline disconnect
designed specifically for installations that
do not have a "Start Signal" available to
initiate ejection of the shoreline. The unit is
wired to the ignition or brake lights and
ejection occurs when the driver steps on the
foot brake to shift into gear. An internal
switch prevents the solenoid from operating
when no shoreline is detected.
cover color choice as above.
SUPER SPECIAL 20 AUTO EJECT
choice of 6
cover colors
Non auto eject 20A
power input receptacle kit,
plastic weatherproof cover,
plastic water tight enclosure
and a liquid tight connector
for wire diameter 0.170 min to
0.470 max
This 120 Volt, 20 Amp
male power inlet
receptacle is for
those installations in
which power is brought
to the vehicle but an
Auto Eject is not
desired.
12 AWG, 3 conductor
cord with an extended
length of 20 feet.
Spring Retractable with Latch
Wall or Ceiling Mount
45 Foot, 12AWG, 3Conductor
Cord
Adjustable Cord Stop
45 FT. Retractable Cord
Reel 12AWG Cable
Retractile Cord
Cannot Re-Latch Unless
Connected to Vehicle
Fully Automatic Power Dropout
Integral GFI and Circuit Breaker
Rugged IP67 Casing
Easy installation
Input: 120 volts A.C., 50/60 Hz
Output: 120 volts A.C., 20 amperes
Sensitivity: 60 miliamperes
Warranty: 3 Years
Protect against electric shock from shore power lines. Intended for
use with the Auto Eject and the Auto Charge battery charger, the
Auto Safe makes shore power lines go dead immediately upon
ejection/disconnection from the vehicle.
The Auto Safe cannot be reset until the power line is re-connected
to the vehicle.
A circuit breaker and ground fault interrupter, GFCI, are included to
provide circuit protection and to eliminate having to install these
items seperately.
AUTO SAFE GFI , Circuit Breaker, and Disconnect switch
EV-PROPULSIONllc
conversions since 1975
QUALITY ELECTRIC VEHICLE CONVERSIONS AND QUALITY PARTS
NEW ITEMS
OUTDOOR RATED 120V / 15A BOAT
LIFTS, PUMPS, PRESSURE
WASHERS Ground Fault Interrupters (
GFCI USER ATTACHABLE GFCI PLUG
UL CSA NEMA 5-15P 120V / 15A
ACCEPTS 18 TO 12 GA SJT CABLE
GFCI RIGHT ANGLE CORD SET
UL CSA OSHA NEC NEMA 5-15P & R
14/3 GA STJW-A WIRE 9"
120V 15 AMP OUTDOOR RATED